Now that the Awlgrip is sprayed on and curing, Kemba’s team changed gears and ground away all the filler around the cracks on the bow and around the strut. With the launch set to 3pm on Tuesday, the clock is ticking and the team set up floodlights to work late into the evening to get at least all the outside fiberglass and filler work completed. And they just did after 4 layers of epoxy and then filler on top.
We were quite lucky that they found these cracks as the about 1 cm thick filler (way to thick of a layer of filler) was not only of poor quality (autobody filler that does not do well with salt water) but also not connected to the epoxy underneath. With the vibration caused by running the engine, this could have ended very badly…
The inside (in the aft cabin) is prepared, ie all the old material has been cut away, and the final fiberglass work will start tomorrow morning. The plan is to put 6 layers of epoxy mats in. Makes you nervous with the light shining through the currently thin floor.
Of course, the wind picked up when they removed all the screens and covers in the aft cabin so that a lot of the dust that these screens were supposed to prevent from making it into the boat – made it into the boat.
We’ll have to throw all the sleeping bag, towels, pillows of the aft cabin in the washing machine tomorrow, but should be good to go then.
In the meantime, we enjoyed a nice Roti lunch at our favorite lunch hang-out before Cathy, Lauren and Corinna took care of the non-perishable groceries, while Peter and Philip stowed away all the sails, covers etc.
We even managed to put the main back on, while still under the shrink-wrap cover. After some struggle, Peter and some helpers managed to put the steering wheel back on.
Lots of other smaller items got taken care of and we believe we can complete all the remaining items by tomorrow in time for the 3pm launch.
Again, dinner (food and drinks at the waterfront) did not disappoint.